ClanCells.com - Club De Técnicos En Telefonía Móvil

Selected USB connection type
Work ID: 000000000085BA53
Checking data...OK
Platform: LG MTK
Selected port: COM1
Selected baudrate: 921600
Selected model: X120HM
Please, disconnect cable, power phone OFF, connect P999 cable
(with 910k resistor)
or
Power OFF phone, press and hold "Vol+" for 10 seconds and
connect USB cable.
Phone found at port COM66
Mode: Emergency
Initializing flash...OK
Model ID: LM-X120HM
Platform: mt6739
Android version: 9
SW version: LMX120HMAT-00-V10d-SCA-XXX-JUN-25-2020+0
LAF Version: 1.1
Product ID: WI07S200729002019
IMEI: 356277-10-73XXXX-X
Target operator: LAO
Hardware: rev_10
Battery level: 37%
Reading partitions...OK
LAF Error: 80000119.
Checking security...OK
--------------------------------------------------------------------------------
IMEI: 356277-10-73XXXX-X
Bluetooth address: Unknown
Wi-Fi MAC address: Unknown
--------------------------------------------------------------------------------
Write security backup function doesn't work for this device with
latest firmware versions. If you'll encounter any problem during
Repair IMEI operation - you won't be able to restore the phone to
it's initial state, so proceed at your own risk.

Continue?
Creating EEPROM backup...OK
Initializing flash...OK
Reading security area...
Backup saved to "X120HM_3562771073XXXXX_02-02-2021_15-
34-26.EEP"
Connecting to server...OK
Octopus smart card is present.
Checking smart card...OK
Username: udfXXXX
Authorizing...OK
Checking balance...OK
Checking operation...OK
Sending device information...OK
Get credits, needed for current operation...OK
Your balance: 218 credits.
To perform "Repair IMEI" operation you need to have 100 credits.
Fixing IMEI...
New IMEI A: 356277-10-73XXXX-X
Patching security...
Writing security area...
Initializing flash...OK
Writing security area...OK
Initializing flash...OK
Reading partitions...OK
Prepairing for change protect status...
Initializing flash...OK
Removing write protection...OK
Initializing flash...OK
Reading partitions...OK
Erasing part 1...OK
Initializing flash...OK
Erasing part 2...OK
Initializing flash...OK
Reading partitions...OK
Prepairing for change protect status...
Initializing flash...OK
Restore write protection...OK
Initializing flash...OK
Reading partitions...OK
IMEI successfully fixed!
Warning: If your device were stuck at logo, after operation was
completed, then please, don't reflash your device, first contact with
Support via Skype or create thread at forum!
Performed by 3.0.7 Software version.